欧美3,亚洲美免无码中文字幕在线,久久久久久久综合综合狠狠,在熟睡夫面前侵犯我在线播放

歡迎進入濟南濟柴環能燃?xì)獍l(fā)電設備有限公司官網!
當前位置:首頁 - 新聞中心 - 行業資訊

行業資訊

發電機組機油為何會變質過快

返回 2022.12.13 來源:http://www.a7716.cn 0
發電機組一般運行500h后應更換機油一次,但有時候未到更換期,或還沒用多長時間就出現機油變稀雜質增多現象,無法繼續使用。那么發電機組機油為何會變質過快?下面焦化發電機組廠家為您解說。
Generally, the engine oil of the generator set should be replaced once after 500h of operation, but sometimes the replacement period is not reached, or the engine oil has become thinner and impurities have increased within a short period of time, which makes it impossible to continue to use. Then why does the engine oil of the generator set deteriorate too quickly? The coking generator set manufacturer will explain it to you.
①機油牌號不對質量達不到要求,一般增壓和標定轉速大于2000r/min的發電機應選用CC級以上的機油;
① The engine oil grade is incorrect and the quality cannot meet the requirements. Generally, the engine oil of CC grade or above shall be used for the generator with supercharging and rated speed greater than 2000r/min;
②機發電機技術狀況不好,竄氣竄油配合間隙過大或油溫過高;
② The technical condition of the generator is not good, the air and oil leakage clearance is too large or the oil temperature is too high;
③機發電機經常在低溫低負荷低速下運轉,活塞變形量不夠,燃燒不完全,有沿缸壁進入油底殼使機油稀釋變質;
③ The generator often operates at low temperature, low load and low speed, the piston deformation is not enough, the combustion is incomplete, and the oil enters the oil pan along the cylinder wall to dilute and deteriorate the oil;
焦化發電機組
④廢氣進入油底殼凝結成水分和酸性物質,使機油變質;
④ The waste gas enters the oil pan and condenses into water and acid substances, which will deteriorate the engine oil;
⑤機油濾芯臟,未經濾清的臟機油進入潤滑部位,加速了零件的磨損。
⑤ The oil filter element is dirty, and the unfiltered dirty oil enters the lubricating part, which accelerates the wear of parts.
⑥濾芯密封圈破裂而發生內漏,一部分機油未經濾芯而直接通過濾清器而造成機油變質。
⑥ The sealing ring of the filter element is broken and internal leakage occurs. Some oil passes through the filter element without passing through the filter element, causing oil deterioration.
發電機組機油為何會變質過快的問題,我們從6個方面來解答了,當然您在使用前后記得檢查各個方面的事項,有助于您順利工作。更多相關類型的發電機事項就來我們網站http://www.a7716.cn咨詢吧!
We have answered the question of why the engine oil of the generator set deteriorates too quickly from six aspects. Of course, you should remember to check all aspects before and after use, which will help you work smoothly. More related generator issues can be found on our website http://www.a7716.cn Consult!
新聞搜索
濟南濟柴環能燃?xì)獍l(fā)電設備有限公司
  • 服務熱線

    0531-62325028
    0531-69951266

發電機組機油為何會變質過快

發電機組一般運行500h后應更換機油一次,但有時候未到更換期,或還沒用多長時間就出現機油變稀雜質增多現象,無法繼續使用。那么發電機組機油為何會變質過快?下面焦化發電機組廠家為您解說。
Generally, the engine oil of the generator set should be replaced once after 500h of operation, but sometimes the replacement period is not reached, or the engine oil has become thinner and impurities have increased within a short period of time, which makes it impossible to continue to use. Then why does the engine oil of the generator set deteriorate too quickly? The coking generator set manufacturer will explain it to you.
①機油牌號不對質量達不到要求,一般增壓和標定轉速大于2000r/min的發電機應選用CC級以上的機油;
① The engine oil grade is incorrect and the quality cannot meet the requirements. Generally, the engine oil of CC grade or above shall be used for the generator with supercharging and rated speed greater than 2000r/min;
②機發電機技術狀況不好,竄氣竄油配合間隙過大或油溫過高;
② The technical condition of the generator is not good, the air and oil leakage clearance is too large or the oil temperature is too high;
③機發電機經常在低溫低負荷低速下運轉,活塞變形量不夠,燃燒不完全,有沿缸壁進入油底殼使機油稀釋變質;
③ The generator often operates at low temperature, low load and low speed, the piston deformation is not enough, the combustion is incomplete, and the oil enters the oil pan along the cylinder wall to dilute and deteriorate the oil;
焦化發電機組
④廢氣進入油底殼凝結成水分和酸性物質,使機油變質;
④ The waste gas enters the oil pan and condenses into water and acid substances, which will deteriorate the engine oil;
⑤機油濾芯臟,未經濾清的臟機油進入潤滑部位,加速了零件的磨損。
⑤ The oil filter element is dirty, and the unfiltered dirty oil enters the lubricating part, which accelerates the wear of parts.
⑥濾芯密封圈破裂而發生內漏,一部分機油未經濾芯而直接通過濾清器而造成機油變質。
⑥ The sealing ring of the filter element is broken and internal leakage occurs. Some oil passes through the filter element without passing through the filter element, causing oil deterioration.
發電機組機油為何會變質過快的問題,我們從6個方面來解答了,當然您在使用前后記得檢查各個方面的事項,有助于您順利工作。更多相關類型的發電機事項就來我們網站http://www.a7716.cn咨詢吧!
We have answered the question of why the engine oil of the generator set deteriorates too quickly from six aspects. Of course, you should remember to check all aspects before and after use, which will help you work smoothly. More related generator issues can be found on our website http://www.a7716.cn Consult!